Victron Energy Battery Chargers

BLUESMART IP67

BlueSmart IP67 Chargers 12V 7/13/17/25 Amp - 24V 4/8/12 Amp
BlueSmart IP67 1.jpg

Bluetooth Smart enabled

The Blue Smart IP67 Charger is the wireless solution to monitor voltage and current, to change settings and to update the charger when new features become available.
With Bluetooth, the functionality of the IP67 charger is enhanced and is similar to that of our IP22 and IP65 chargers.

Completely encapsulated: waterproof, shockproof and ignition protected

Water, oil or dirt will not damage the Blue Smart IP67 Charger. The casing is made of cast aluminium and the electronics are moulded in resin.

The highest efficiency ever!

Setting a new industry standard: with 92% efficiency or better, these chargers waste three to four times less heat. And once the battery is fully charged, power consumption reduces to less than a Watt, some five to ten times better than the industry standard.

Adaptive 5-stage charge algorithm: bulk – absorption – recondition – float – storage

The Blue Smart Charger features a microprocessor controlled ‘adaptive’ battery management. The ‘adaptive’ feature will automatically optimise the charging process relative to the way the battery is being used.

Storage Mode: Less maintenance and aging when the battery is not in use

The storage mode kicks in whenever the battery has not been subjected to discharge during 24 hours. In the storage mode float voltage is reduced to 2,2 V/cell (13,2 V for a 12 V battery) to minimise gassing and corrosion of the positive plates. Once a week the voltage is raised back to the absorption level to ‘equalize’ the battery. This feature prevents stratification of the electrolyte and sulphation, a major cause of early battery failure.

Also charges Li-ion (LiFePO4) batteries

LiFePO4 batteries are charged with a simple bulk – absorption – float algorithm.

Protected against overheating

Can be used in a hot environment such as a machine room. Output current will reduce as temperature increases up to 60°C, but the charger will not fail.

Two LEDs for status indication

Yellow LED: bulk charge (blinking fast), absorption (blinking slow), float (solid), storage (off) Green LED: power on

BlueSmart IP67 12/7 12/13 12/17 12/25 24/5 24/8 24/12
Input voltaje range and frequency 180 - 265 Vac 45-65 Hz
Efficiency 93 % 93 % 95 % 95 % 94 % 96 % 96 %
No load power consumption 0,5 W
Charge voltage "absorption" Normal: 14,4 - Hight: 14,7 - Li-ion: 14,2 Vcc Normal: 28,8 - Hight: 29,4 -  Li-ion: 28,4 Vcc
Charge voltage "float" Normal: 13,8 - Hight: 13,8 - Li-ion: 13,5 Vcc Normal: 27,6 - Hight: 27,6 -  Li-ion: 27,0 Vcc
Float voltage "storage" Normal: 13,2 - Hight: 13,2 - Li-ion: 13,5 Vcc Normal: 26,4 - Hight: 26,4 -  Li-ion: 27,0 Vcc
Charge current, normal mode  7 A 13 A 17 A 25 A 5 A 8 A 12 A
Charge current, LOW 2 A 4 A 6 A 10 A 2 A 3 A 4 A
Charge algorithm 5 - stage adaptive
Can be used as power supply yes
Protection Battery reverse polarity (fuse), Output short circuit, Over temperature
Operating temperature range

-20 to +60 ºC (full rated output up to 40 ºC)

Derate 3% per ºC above 40 ºC

Humidity Up to 100%

Start interrupt option (Si)

(12/24 and 24/12 models only)

Short circuit proof, current limit 0,5 A

Output voltage: max one volt lower than main output

Enclosure
Material & colour Aluminium (blue RAL 5012)
Battery-connection Black and red cable of 1,5 meter
230 Vac connection Cable of 1,5 meter with CEE 7/7 PLUG
Protection category IP67
Weight 1,8 Kg 1,8 Kg 2,4 Kg 2,4 Kg 1,8 Kg 2,4 Kg 2,4 Kg
Dimensions (h x w x d) 85 x 211 x 60 mm 85 x 211 x 60 mm 99 x 219 x 65 mm 99 x 219 x 65 mm 85 x 211 x 60 mm 99 x 219 x 65 mm 99 x 219 x 65 mm
Standards
Safety EN 60355-1, EN 60355-2-29
Emission Immunity EN 55014-1, EN 61000-6-3, EN 61000-3-2
Automotive directive EN 55014-2, EN 61000-6-1, EN 61000 6-2, EN 61000-3-3

 

Catálogo General 2020

  • BlueSmart IP67 1.jpg
  • BlueSmar IP67 2.jpg

Do you want more information about this product?

bornay@bornay.com  |  (+34) 965 560 025  |  Skype