MULTIPLUS 500 - 1600 VA

The MultiPlus is set to replace the earlier MultiPlus Compact range. It is a powerful true sine wave inverter, a sophisticated battery charger that features adaptive charge technology and a high-speed AC transfer switch in a single compact enclosure.
Multiplus 1.jpg Multiplus
Multiplus 2.jpg Multiplus
Multiplus 3.jpg Multiplus
Multiplus 4.jpg Multiplus


[page1image3116638368]

Proven reliability

The full bridge plus toroidal transformer topology has proven its reliability over many years.
The inverter is short circuit proof and protected against overheating, whether due to overload or high ambient temperature.

PowerControl - Dealing with limited generator, shore side or grid power

With the Multi Control Panel a maximum generator or shore current can be set. The MultiPlus will then take account of other AC loads and use whatever is extra for charging, thus preventing the generator or shore supply from being overloaded.

PowerAssist - Boosting the capacity of shore or generator power

Where peak power is so often required only for a limited period, the MultiPlus will make sure that insufficient shore or generator power is immediately compensated for by power from the battery. When the load reduces, the spare power is used to recharge the battery.

High start-up power

Needed to start high inrush loads such as power converters for LED lamps, halogen lamps or electric tools.

Search Mode

When Search Mode is ‘on’, the power consumption of the inverter in no-load operation is decreased by approx. 70%. In this mode the Multi, when operating in inverter mode, is switched off in case of no load or very low load, and switches on every two seconds for a short period. If the output current exceeds a set level, the inverter will continue to operate. If not, the inverter will shut down again.

Programmable relay

By default, the programmable relay is set as an alarm relay, i.e. the relay will de-energise in the event of an alarm or a pre-alarm (inverter almost too hot, ripple on the input almost too high, battery voltage almost too low).

Specifications

Multiplus

12/500/20

24/500/10

48/500/6

12/800/35

24/800/16

48/800/9

12/1200/50

12/1200/25

12/1200/13

12/1600/70
24/1600/40

48/1600/20

PowerControl / Power Assist Yes / No Yes / Yes
Transfer switch 16 
Inverter
Input voltage range 9,5 - 17 V     19-33 V.    38 - 66 V
Output Voltage 230 Vca +/- 2%
Output Frequency 50 Hz +/- 0,1%
Cont. Output power at 25 ºC 500 VA 800 VA 1200 VA 1600 VA
Cont. Output power at 25 / 40 / 60 ºC 430 / 400 / 300 W 700 / 650 / 400 W 1000 / 900 / 600 W 1300 / 1100 / 800 W
Peak Power 900 W 1600 W 2400 W 2800 W
Maximum efficiency 90 / 91 / 92 % 92 / 93 / 94 % 94 / 94 / 95 % 93 / 94 / 95 %
Zero-Load power 6 / 6 / 7 W 7 / 7 / 8 W 10 / 9 / 10 W

10 / 9 / 10 W

ECO-Load power 3 / 2 / 3 W 2 / 2 / 3 W 3 / 3 / 3 W 3 / 3 / 3 W
Charger
AC Input 185 - 265 Vac / 45-65 Hz
Charge voltage "absorption" 14,4 / 28,8 / 57,6 V
Charge voltage "float" 13,8 / 27,6 / 55,2 V
Storage mode 13,2 / 26,4 / 52,8 V
Charge current house battery 20 / 10 / 6 A 35 / 16 / 9 A 50 / 25 / 13 A 70 / 40 / 20 A
Charge current aux. battery 1 A (12 and 24 volts models only)
Battery temperature sensor Yes
General
Programable relay Yes
Protection

Output short circuit
Overload

Battery voltage too high
Battery voltage too low
Temperature too high
230VAC on inverter output g. Input voltage ripple too high

VE.Bus communication port

For parallel and three phase operation, remote monitoring and system integration

(RJ45-spliter ASS030065510 needed for 500/800/1200VA models)

Remote on-off On / Off / Charger only On / Off
DIP Switches

Yes

(remote, battery charge voltage, inverter frequency, search mode)

Yes

(Bat charge volt, Search mode)

Internal DC fuse 125 / 60 / 30 A 150 / 80 / 40 A 200 / 100 / 50 A 200 / 125 / 60 A
Temperature -40 to + 65 ºC (Fan assisted cooling)
Humidity Max. 95% (non-condensing)
Enclosure
Material & Colour Steel / ABS  (Blue RAL 5012)
Protection category IP 21
Battery connection 16 / 10 / 10 mm2 25 / 16 / 10 mm2 35 / 25 / 10 mm2 50 / 35 / 16 mm2
230 Vac connection G-STI 18i connector
Weight 4,4 Kg 6,4 Kg 8,2 Kg 10,2 Kg
Dimensions ( h x w x d) 311 x 182 x 100 mm 360 x 240 x 100 mm 406 x 250 x 100 mm 470 x 265 x 120 mm
Standards
Safety

EN-IEC 60335-1, EN-IEC 60335-2-29, EN 62109-1

Emission / Immunity

EN 55014-1, EN 55014-2, EN-IEC 61000-3-2, EN-IEC 61000-3-3 IEC 61000-6-1,

IEC 61000-6-2, IEC 61000-6-3

Automotive ECE-R10-5
 

Downloads

Catálogo General 2020